Imagine walking up to a stripped bolt and pulling it out in under a minute instead of spending hours grinding, drilling, and cursing at a tiny piece of metal that won't budge.

No more switching between five different tools that slip off or snap in half.

Grabit® Pro bites into any stripped fastener and pulls it straight out. Works on bolts stuck in wood, metal, or plastic.

Pulls out Phillips heads, hex bolts, Torx screws, even those cheap soft screws that strip if you look at them wrong.

Made from industrial-strength tool steel that won't snap off inside your bolt and turn a bad day into a nightmare.

You're mid-extraction and your bargain store extractor snaps clean off inside the damaged screw.

Now you have a piece of hardened steel permanently wedged where the screw used to be, turning a fixable problem into an impossible nightmare.

Cheap extractors use soft, brittle steel that can't handle the torque needed to break free a seized fastener. They're designed to look like the solution but fail right when you need them most.

Our M2 HSS tool steel is tempered twice to achieve industrial-grade hardness that grips and holds without shattering.

Extract bolt after bolt with complete confidence.

You're drilling and grinding, trying every destructive method you know.

The fastener finally gives, but now the surrounding metal is gouged and the threads are destroyed, forcing you to replace a $500 part because of a 5 cent screw.

Standard removal methods require cutting, chiseling, or aggressive drilling that treats the entire assembly as collateral damage.

Our dual-sided design drills a precise pilot hole then extracts from within, leaving surrounding threads and surfaces completely untouched.

Walk away with a clean removal every time.

You're staring at a snapped Grade 8 bolt in your engine block, and your extractor set maxes out at standard hardware store strength. You know before you even try that your tools aren't hard enough to grip this industrial fastener.

Regular extractors are built for basic DIY screws and soft metals. When you face hardened, industrial-grade fasteners, those tools just spin uselessly or strip out the pilot hole.

Our professional-strength M2 HSS bites into Grade 8 and 10.9 class fasteners without hesitation.

Handle the impossible extractions that defeat everyone else.

It's been three hours and you're still wrestling with the same stripped screw.

You've tried vice-grips, a Dremel slot, penetrating oil, and heat, and that fastener is still mocking you from the same position it started.

Traditional removal methods require multiple tools, waiting periods for chemicals to work, and trial-and-error approaches that waste your entire weekend on a single fastener.

Our drill-and-extract system works in one continuous motion with the tool you already have in your hand.

Finish your repair and move on with your day.