How to Use Grabit® Drill-Out Broken Bolt Extractors
Learn how to use Grabit® Drill-Out for broken bolt and stud removal. Its drill and adjustable extractor collar work together, with a different setup from Grabit Pro and Grabit Micro.
Watch: How to Use Grabit Drill-Out
Watch the Grabit Drill-Out how-to video on YouTube.
Before you begin
Wear eye protection. Use a 3/8-inch variable-speed reversible drill. Read the manufacturer's Drill-Out operating instructions, using the standard Drill-Out section on page 1.
Step 1: Set up and drill
Choose the correct size and secure the tool's shank in the chuck. Wind the extractor collar back against the chuck. Keep the drill in reverse and drill straight into the bolt's center at the size-specific speed in the instruction chart. Keep the collar from traveling toward the tip. Stop before it touches the bolt; apply penetrating oil.
Step 2: Position the extractor collar
With the drill stopped, advance the collar five turns away from the chuck. It must engage the hole's top before the drill tip reaches the bottom.
Step 3: Extract the broken bolt
Keep reverse selected. Hold the drill with both hands, bring it to the chart's extraction speed and press the tool into the hole. The collar grips to turn the bolt out.
If the drill stalls
Stop. Consult the manufacturer's wrench-removal procedure and continued-resistance guidance before proceeding.
Frequently asked questions
Do I flip the bit like Grabit Pro?
No. This guide covers Drill-Out's adjustable collar design.
Which kit should I choose?
The 4017P four-piece kit covers bolt sizes from 1/4 to 1/2 inch (6–12 mm). Check its removal chart for the correct tool for your bolt.