How to Use Grabit® Micro Screw & Bolt Extractors
Grabit® Micro uses a cutter end to prepare a centered hole and an extractor end to remove the damaged fastener. Follow this guide alongside the operating instructions supplied with your tool.
Watch: How to Use Grabit Micro
Watch the Grabit Micro how-to video on YouTube.
Before you begin
Wear protective eyewear. Select the extractor using the Grabit Micro operating instructions and size chart. Use a variable-speed reversible drill with a suitable chuck; impact or high-horsepower drills may damage the tool. Disconnect power before fitting or reversing the extractor.
Step 1: Drill the centered hole
Clamp the round shaft in the chuck, leaving the cutter exposed. Use reverse throughout. Start at the fastener's center at approximately 70–100 rpm. Check alignment early and keep the tool straight. Pause every 10 seconds or 1/16 inch (2 mm) of depth to clear chips and add cutting oil. Stop at the point where the hex shaft begins.
Step 2: Flip the tool
Clear the hole and apply penetrating oil around the fastener's edges. Disconnect power, flip the tool and secure its hex shaft in the chuck.
Step 3: Extract slowly
Keep reverse selected. Hold the drill firmly with both hands, seat the extractor in the hole and apply pressure toward the fastener. Extract at approximately 30–70 rpm.
If extraction stalls
Stop rather than forcing the tool. Review the instruction sheet's alignment checks and manual-removal procedure before proceeding.
Frequently asked questions
Is Micro preparation the same as Pro burnishing?
No. Micro's instructions specify drilling a centered hole with the cutter end.
Which size should I choose?
Match your fastener to the manufacturer's chart linked above. Do not assume every small screw suits the same extractor.