”image”

How to Use Grabit® Pro Screw Extractors

Learn how to use Grabit® Pro to remove a damaged screw with a two-stage process: prepare the screw head with the burnishing end, then flip the tool to extract it.

Watch: How to Use Grabit Pro

Watch the Grabit Pro how-to video on YouTube.

Before you begin

Wear safety glasses and protective clothing. Secure the workpiece and use a variable-speed reversible drill. Check the sizing chart and cautions in the Grabit Pro operating instructions before starting.

Step 1: Burnish the damaged screw head

Fit the tool with its burnishing end exposed. Set the drill to reverse (counterclockwise). Center the tip in the damaged head and work slowly until the recess is smooth and cone-shaped. This prepares the contact surface; it is not a hole-drilling step.

Step 2: Flip and extract

Stop the drill, flip the tool and secure it with the remover end exposed. Keep reverse selected. Seat the tip in the prepared recess and apply firm downward pressure at slow speed and the lowest power setting. The extractor engages the head and backs the screw out.

If the extractor does not grip

Stop and recheck direction, seating and size. The instruction sheet describes further burnishing or a larger remover as possible remedies, but warns that these can damage the head or tool. Review those cautions before trying again.

Frequently asked questions

Do I switch to forward after flipping the bit?

No. Both stages use reverse.

Can I reuse the extractor?

Yes. Remove chips and oil the tool after use.

Find your Grabit Pro

Shop the Alden 8440P Grabit Pro 4-Piece Kit.

Return to the general How to Use page.

Join our Mailing List

Get your discount

Match 3 cards to see what you win